Home/Support/Support Forum/Using Uart to Output Analog Input

Using Uart to Output Analog Input

0 votes
Hello,

I would like to use the Xbee S1 board to read an analog voltage (so using the ADC) and send it out to a board (STM32) through the USART interface. All would be done using one Xbee module

It is possible?
asked Nov 2, 2015 in RF Solutions and XBee by CarloBenussi New to the Community (0 points)
recategorized Nov 6, 2015 by jeremym

Please log in or register to answer this question.

1 Answer

0 votes
Yes it is. See http://knowledge.digi.com/articles/Knowledge_Base_Article/Analog-to-Digital-Conversion-on-the-XBee-802-15-4/?q=xbee+ADC&l=en_US&fs=Search&pn=1 as well as the ADC section of the product manual.
answered Nov 30, 2015 by mvut Veteran of the Digi Community (15,409 points)
...