Home/Support/Support Forum/Replacing Coordinator with Security Enable
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Replacing Coordinator with Security Enable

+1 vote
How can I replace a network coordinator with security key enable ?

XBee Reference number:

XB24-Z7UIT-004 revK

Best Regards
asked Nov 6, 2015 in IEEE 802.15.4 by rsilva New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Have you tried the steps outlined in the manual on pages 48 - 49 with the addition of the KY, NK, EE and EO commands?
answered Nov 9, 2015 by mvut Veteran of the Digi Community (15,107 points)
The manual explicitly says "Security Disable Only", but no I have not tryed assuming that the procedure is not the same.

Thanks
commented Nov 9, 2015 by Rgoncalves New to the Community (1 point)
The process should be very similar with the exception of the above additional commands. Keep in mind that you will need to know what the KY and NK values are in the existing network as these are Non-readable commands.
commented Nov 9, 2015 by mvut Veteran of the Digi Community (15,107 points)
...