Home/Support/Support Forum/XBee Pro 900 Mhz can´t communicate

XBee Pro 900 Mhz can´t communicate

0 votes
Hello everyone.
I am trying to make the 2 XBee modules communicate themselves, but I have no success.
Is there any secret to do that? Changed network ID, channel, nothing.

Any help would be appreciated. :-)
asked Nov 6, 2015 in DigiMesh Proprietary Mesh Networking by claudiohi New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
What is the full part number(s) and firmware versions used on the radios in question?
answered Nov 9, 2015 by mvut Veteran of the Digi Community (13,094 points)
Hello dear mvut. I am using XBP09-DMWIT, firmware v. 8062.

The radios can communicate between themselves, the problem occurs only with Arduino Mega.

Thank you for your help and support.
Have you looked at what is being sent out of the UART of the Arduino to make sure that it is valid data?

How are you connecting the XBee to the Arduino? Are you connecting it direct or using an XBee shield?
0 votes
Reply below,sorry.
answered Nov 9, 2015 by claudiohi New to the Community (1 point)
...