Home/Support/Support Forum/How to enable authentication for private APN
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to enable authentication for private APN

0 votes
Hi,
We are looking at WR21 to replace the fleet of existing Cisco 819G used to connect some remote devices to the corporate network via the wireless 3G.
At the moment we have a private APN create on the carrier network (Telstra Australia) and all C819 routers configured to connect to that APN. The gsm configuration is pretty much simple there:

"cellular profile 0 gsm create 1 PRIVATE_APN chap U1@private_apn U1_PSWD ipv4"

That command instruct the cellular module of C819 to connect to the APN PRIVATE_APN with the username U1@private_apn and the password U1_PSWD. Also please note that the carrier supports only ipv4 connection, but not PPP.

So, when we are trying to replicate that settings on WR21, it's got a bit unclear how to force the router to connect to our APN with the given credentials, but without PPP.

Any ideas are welcome,
Thank you
asked Nov 24, 2015 in Digi TransPort Cellular by totohin New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hi

Normaly when using authentication you would use the PPP instance assosiated with the SIM and use the username and password there

this is the methord the router talks to the mdule in the router and not the network.

so as long as the apn / username/ passowrd /PIN are set this should bring up the interface

regards
answered Nov 25, 2015 by James.Wilson Veteran of the Digi Community (1,227 points)
...