Home/Support/Support Forum/Xbee 900HP Transparent Mode receiving data

Xbee 900HP Transparent Mode receiving data

0 votes
Hi,

I am looking at buying the Xbee 900HP. I want to run it in transparent mode. I notice in the data sheet it doesn't explicitly talk about what happens to data when it's received over the air.

So my question is when data is received over the air is it automatically placed on the DOUT line? If it is is this data in a special format or is it just the raw payload data?
asked Dec 1, 2015 in DigiMesh Proprietary Mesh Networking by walkietalkie123 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
In the radios default configuration, all data sent into the UART of a transmitting radio is sent out as it is received on the receiving modules UART. That is, data In = Data out.
answered Dec 1, 2015 by mvut Veteran of the Digi Community (12,756 points)
...