Home/Support/Support Forum/Programmable point to multipoint

Programmable point to multipoint

0 votes
I would like to utilize an xbee 900hp s3b programmable with point to multipoint firmware, but it is only offered with Digimesh. Can I purchase a Digimesh programmable version then change firmware to point to multipoint?
asked Dec 1, 2015 in XBee Programmable Development by jatrujil New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Yeah, that should be easy.

Just remember to use XBIB interface board while updating firmware. Most 3rd party boards don't have flow control lines which are important during firmware update.
answered Dec 2, 2015 by asgm Veteran of the Digi Community (1,499 points)
You also may need to load the proper code on the free-scale processor first.