Home/Support/Support Forum/XBEE PRO S2C as coordinator for Smart Energy Profile

XBEE PRO S2C as coordinator for Smart Energy Profile

0 votes
I am trying to configure, XBEE PRO S2C as coordinator for Smart Energy profile to communicate with Smart Energy Meters. I am using 5132 firmware version. I am not able to change the Zigbee Protocol Addressing fields. It gives Invalid command in response. On the same XBee pro module the works properly. Please help and tell me, if I am doing anything wrong.
asked Dec 7, 2015 in ZigBee Smart Energy Profile 1.1 by bagdeparag New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
The smart energy code uses API mode for all interactions. Not the AT commands.
answered Dec 7, 2015 by mvut Veteran of the Digi Community (11,818 points)
0 votes
Hey, I am using API command for interaction, still getting "invalid command" in response. Is any other way to change the Zigbee Protocol Addressing parameters like: Source Endpoint, Cluster ID etc.
answered Dec 9, 2015 by bagdeparag New to the Community (1 point)
...