Home/Support/Support Forum/Xbee did not working cyclic sleep mode for a long time.

Xbee did not working cyclic sleep mode for a long time.

0 votes
Hello, everyone.

i'm in trouble.

I use Xbee zb series2 with my project.
Topology was very simple. Just one coordinator, one End-device.

Transmit mode was API mode.

and I tried setting Xbee cyclic sleep (SO:6)

It's wake up every minutes. (SN: 3, SP:7D0)

also I give same sleep settings End device and coordinator (SN and SP).

and power supply is made stable over USB.

I used latest firmware version.




In the beginning it's worked nice.

but after about 2 to 10 hours?

Xbee not send any data.

It looks like freezing.

I want to check Xbee status.

so I used logic analyzer.

but electronically no problem.



I think this problem is S/W.

Please help me!!
asked Dec 9, 2015 in RF Solutions and XBee by sky1027 New to the Community (0 points)
edited Dec 9, 2015 by sky1027

Please log in or register to answer this question.

1 Answer

0 votes
What firmware versions are you working with? Are you able to issue any Remote AT commands?
answered Dec 9, 2015 by mvut Veteran of the Digi Community (12,829 points)
Thank you for your answer.

This is information about your mentioned.


-firmware versions-
End device is XB24-ZB ZigBee End Device API 29A7 (Newest)
Coordinator is XB24-ZB ZigBee Coordinarot API 21A7 (Newest)

-Setting-
End device
ID: 1
SC: 10
DH: coordinator address
DL: coordinator address
NH: 1
AP: 2
SP: 7D0
SN: 3
SO: 6
D0: 1
D5: 5
IR: 0

Coordinator
ID: 1
SC: 10
NH: 1
AP: 2
SP: 7D0
SN: 3

Rest value is setting default.
...