I have to set D0 to 3 (three). If I make XCTU (6.3.0) read the configuration, D0 is reported as Disabled.
Whichever value I set it to, when I write it, I get D0: Status Error.
I've reset the radio through short-circuiting pin5 and pin10.
I see that this question has already been made other times and left unanswered or, at least, without a solution.
Shall I assume that the xBee (XB24-API-001 rev.D) is faulty?
I've also tried to update the firmware from 10ee to 10ef (newest). I succeded but, with the warning of an error on RR (status error).
I still cannot update D1, in addition also RR is no more updatable, giving the error STATUS ERROR.
I keep asking: "Shall I assume it's faulty? two days after receving it?.
Thanks in advance