Home/Support/Support Forum/Portserver TS4 MEI not saving configuration settings
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Portserver TS4 MEI not saving configuration settings

0 votes
I reset a Portserver TS MEI to factory defaults and when I change the settings (IP address, submask, etc.) in command-line mode, the settings do not get changed.

I can swap the TS with different units of the same model and it works OK on the other units.

Does this indicate a defect in the TS, or am I doing something wrong?
asked Jan 19, 2016 in Serial Servers by rearl New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
This indicates a problem with the TS unit (possible bad flash). You should contact Digi Tech. Support to pursue possible repair.
answered Jan 20, 2016 by userid0 Veteran of the Digi Community (2,158 points)