Home/Support/Support Forum/Set up of async term to interact with USB-ftdi adapter and xBee

Set up of async term to interact with USB-ftdi adapter and xBee

0 votes
I need to use AT commands over a USB-FTDI explorer to a xBee. I know the name, speed and so on.
Can anyone explain how to do it?
So far, I've used CoolTerm on OSX. I point CoolTerm to the right port, 9600, N, 8, 1.
I've assumed that I should issue the following:
+++ (alone without CR)
ATD1 2 + CR
ATWR + CR and so on

But I never have an OK after the three +s.
Anyone out there using this combination? Which parameters have you set?
Thanks, Elio

P.S.
XB24-API-001 rev.D
FCC ID OUR-XBEE
IC 4214A-XBEE
asked Jan 21, 2016 in IEEE 802.15.4 by giumbolo New to the Community (1 point)
edited Jan 21, 2016 by giumbolo

Please log in or register to answer this question.

1 Answer

0 votes
What is the exact part number of the xbee module you are working with?
answered Jan 21, 2016 by mvut Veteran of the Digi Community (11,298 points)
XB24-API-001 rev.D
FCC ID OUR-XBEE
IC 4214A-XBEE
What happens when you use XCTU's terminal function? Are you able to enter command mode or read the radio?

You mentioned using a USB connection? Who's USB device are you using and how is the module connected to it?
...