Home/Support/Support Forum/Current consumption at XBee power up

Current consumption at XBee power up

0 votes

I am using the end-node XBee in its standard protocol (I have no possibility to change it through XCTU). Details of configuration are in the following (AT mode):

- Module type: XBP08-DP
- Family: XBee-PRO868
- Protocol: point to multipoint
- Firmware: 1061
- Configuration: End Node in cyclic sleep

Only the coordinator is set in API mode.

The problem is due to an unwanted current consumption in correspondence of the power up, as you can see in the image at the following link:


(the button 'scarica' is needed to download the image).

How can I take control of this behaviour? Another question is: ND and DN command are not present in the XCTU window: have I change the firmware version?

Many thanks for your answer!
asked Feb 9, 2016 in RF Solutions and XBee by Johnny2 New to the Community (0 points)
reshown Feb 10, 2016 by rmaroun

Please log in or register to answer this question.

1 Answer

0 votes
This is a duplicate question from the same customer. Please see the other respond or chain.
answered Feb 9, 2016 by mvut Veteran of the Digi Community (15,320 points)