Hello to everyone,
I attach at the following link an oscilloscope screenshot reporting the unwanted power consumption of XBee-Pro868 at each power up (power transmission 1 mW):
The XBee module is configured as follows:
- Module type: XBP08-DP
- Family: XBee-PRO868
- Protocol: point to multipoint
- Firmware: 1061
- Configuration: End Node in cyclic sleep
How can I take control of this unwanted behaviour? By using XCTU, lots of AT command reported in the manual are not implemented (e.g. JN, ND, DN,...) so I don't know how to set properly my module.
Many thanks in advance for you reply.