Home/Support/Support Forum/DIN and I/O Line Blinking

DIN and I/O Line Blinking

0 votes
Hi,

I have an XBee Pro S1 (XBP24-ASI-001) and I'm only doing I/O line passing with it. About every 6 seconds, any output line that's on, blinks off for roughly 1/10 of a second.

If I connect anything, including an unconnected wire, to DIN, the blinking stops. Right now I'm pulling DIN low through a 5k resistor and it's not blinking.

Should I pull it high or low? Is there something that is happening that could be stopped with a certain setting?

I'm only using DIN to program my XBee. I'm only doing I/O line passing and when I don't have my programmer plugged into DIN, I don't have anything connected to DIN.

Thanks,
Albert
asked Feb 24, 2016 in Miscellaneous Hardware and Software by ChiefAlbert New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Try using a Sample rate instead of change detect on your Digital Input side. Also don't leave any Inputs floating. They need to be Tied to Ground.
answered Feb 25, 2016 by mvut Veteran of the Digi Community (11,302 points)
...