Home/Support/Support Forum/Can helping me , imu and 2 servos??

Can helping me , imu and 2 servos??

0 votes
I made a project imu its result send to 2 servos by using xbee with arduino, but the code doesn't work???
asked Mar 6, 2016 in XBee Programmable Development by Shaimaa New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
In this application, the XBee modules should be nothing more than a 3V CMOS cable replacement between the devices. What I would suggest is start by taking the radios out of the picture and simply wire it as a direct COM port. Then adjust your code accordingly.

Once you have done that, you can then put the radios in between using transparent mode and no changes to your code.
answered Mar 7, 2016 by mvut Veteran of the Digi Community (11,300 points)
...