I have been running a ZB network successfully for some time with coordinator in API(1) mode and three routers in AT mode. All are Series 2
I wanted to experiment with end device sleep for the first time, so I set up one coordinator in API and one end device in AT.
The sleep setup was mode 5 (cyclic with pin wake), SP = 20000-mS, SN = 0xF (5-minute cyclic).
This worked nicely on it's own PAN ID.
There were a few erratic cyclic times (too short or too long), so I thought it might improve things if I moved it to the existing network.
I changed the PAN to the existing PAN and the data frames started coming through.
However, the end device cyclic times weren't 5-minutes any more, but 1-minute 23-seconds, obviously not the set time - the pin awake was not being used.
Changing the end device over to the original coordinator (PAN changed) restored the correct timing.
I been over all the settings, reset devices, but every time it is used on the larger network, the cyclic time goes to the wrong timing.
I would like to get an end device working properly, but I'm stumped at the moment.
Any suggestions please?