Home/Support/Support Forum/WR44: Need help to steup Static IP address on each of the physical Ethernet port?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

WR44: Need help to steup Static IP address on each of the physical Ethernet port?

0 votes
I want to setup my modem router to give static IP address to each of the 4 available ethernet port and share the internet at the same time. As I understand, this can be done using Port Isolate Mode, but I was unable to get it to work. I only manage to set the static IP from each ethernet port but not sharing of the internet. I need this going so that I can get remote access to instruments via the internet.
asked Jun 21, 2010 in Digi TransPort Cellular by hoj.oeh New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hi,

If you want to share internet then you need to use HUB mode not port isolate mode.

Note: While assining static IP address make sure all the ports are in the same network.
answered Jul 18, 2012 by Yeshas Community Contributor (72 points)
...