Home/Support/Support Forum/ATAS (Active Scan) always gives ERROR

ATAS (Active Scan) always gives ERROR

0 votes
Not able to do Active Scan of AP in the visinity using AT Command. Command always replies with ERROR

ATAS - ERROR

Tried both in Command mode and API mode.

Device info:

Xbee S6B SMT module
Fw Version :2026
asked Mar 23, 2016 in IEEE 802.11 (Wi-Fi) by Mundhazir Lathef New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

0 votes
The command will report Error if the module is already associated with an Access point. You may need to issue the NR command first in order to use the AS command.
answered Mar 24, 2016 by mvut Veteran of the Digi Community (12,544 points)
Thanks a lot!

I will update here once I try the same.
...