Home/Support/Support Forum/need to configure end device?

need to configure end device?

0 votes
Hi
I want to check the communication among coordinator - router - end device. I searched and found the way to set up coordinator on XCTU next gen but couldn't find any info how to configure router and end device. My device is XBEE S2C. Would anyone help?
asked Apr 18, 2016 in DigiMesh Proprietary Mesh Networking by fuyacho New to the Community (2 points)

Please log in or register to answer this question.

2 Answers

0 votes
The module comes pre configured as a Router so no change is needed with that aspect. To enable end device, simply set the SM command to a value other than 0. You see End devices are sleeping by nature. So setting it as a sleeping device turns it into an End device.
answered Apr 18, 2016 by mvut Veteran of the Digi Community (15,156 points)
0 votes
Hi mvut,
thanks a lot for the answer.
What a indirect setting....but it is understandable.
answered Apr 19, 2016 by fuyacho New to the Community (2 points)
...