Home/Support/Support Forum/How to read/write config XBee programmatically

How to read/write config XBee programmatically

0 votes
I am using XBee ZigBee (S2C) for my project and can use XCTU or command prompt to configure it.

I have many TI microcontroller and Raspberry Pi in the systems that needs to read some info about the XBee connected to it (ID and other configs).

How do I do that programmatically? That is by writing some C code that runs on the device to read/write the XBee config, instead of manually using XCTU or command prompt?
asked Apr 21, 2016 in RF Solutions and XBee by lilyhack New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

0 votes
You have two options. The first is to use the API interface as described on pages 139 - 184 of the manual or you can use AT command mode as described on pages 188 - 207 and 43.

http://ftp1.digi.com/support/documentation/90002002.pdf
answered Apr 21, 2016 by mvut Veteran of the Digi Community (12,302 points)
...