When I enter any show commands on a Cisco switch or a router connected to ports on my portserver II 16, only the first 'x' number of lines of the actual output are displayed and then returns to console. It doesn't give me the option to hit space or enter to see the continued output. I have configured the serial ports as below.
set flow
tty ixon aixon ixoff ixany itoss altpin rts dtr cts dcd dsr ri
1 on off on off off on off off off off off off
set ports
tty termtype dev sess uid edelay auto bin group dport dest
1 vt100 prn 4 0 1 off off 0 0 0.0.0.0
set flow
tty ixon aixon ixoff ixany itoss altpin rts dtr cts dcd dsr ri
1 on off on off off on off off off off off off
Is there a misconfiguration or do I need to configure any other commands?
Thanks.