Home/Support/Support Forum/XBee-PRO rs485 settings

XBee-PRO rs485 settings

0 votes
HI There,

I'm wondering if there is a manual of how to setup a basic RS485 communication.

I have got 3 salve devices and 1 master which all have to communicate over RS485. The devices are at different locations so i have got a total of 4 XBee-PRO 900HP RF modules.

I have read the manual and tried different combinations but it wont work.

Any help in regards to what network type and settings to use would be appreciated.


asked Apr 30, 2016 in Miscellaneous Hardware and Software by gemenergy New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
Did you purchase the RF Modem or just the XBee PRO OEM module?

Which firmware version is installed on each radio?
answered May 2, 2016 by mvut Veteran of the Digi Community (15,112 points)
Hi there,

Thanks for your replay. I exactly managed to work it all out and it works fine.

0 votes
How to set xbee 3 module to handle rs 485
answered Jan 19, 2021 by ramjee New to the Community (1 point)