Home/Support/Support Forum/how to connect xbee end device with coordinator via router only

how to connect xbee end device with coordinator via router only

0 votes
I dont wish my end device to connect to coordinator directly, but via router. Is there any setting needed?? Thanks in advanced.
asked May 3, 2016 in DigiMesh Proprietary Mesh Networking by hongshiong New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

+1 vote
 
Best answer
Yes, set NJ on the Coordinator to 0x00 after the router joins and before you power on the End device for the first time. This will allow the router to join and no other nodes join the Coordinator. Then when you turn on the end device, it will be forced to join the router.
answered May 3, 2016 by mvut Veteran of the Digi Community (12,001 points)
selected May 3, 2016 by hongshiong
...