Home/Support/Support Forum/Changing direction of a 8 bit port using Code

Changing direction of a 8 bit port using Code

0 votes
we are trying to interface the XBEE900HP module with one of our other MCU using parallel interface of 8 bits(8GPIO). just wondering is there a way of changing the direction of the port using the code? because xbee will transmit on the parallel interface but it also need to receive, therefore need to change the direction of the GPIO regularly .
asked May 26, 2016 in XBee Programmable Development by e.bektasevic New to the Community (0 points)

Please log in or register to answer this question.

...