Home/Support/Support Forum/How to change the GPIOs state of the digi connect me 9210 with firmware?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

How to change the GPIOs state of the digi connect me 9210 with firmware?

0 votes
I have got a digi connect me 9210 module with plug N play firmware,But when I used web pages or the commandline to configure the GPIOs,I found the states of GPIOs cannot change immediately.I want to control some LEDs thru GPIOs.I have read the commandline reference of DIGI family,but I cannot find some solutions.I have connected your agent in shanghai,but he could not give me some help.
I'm looking forword for your reply,Thank you very much!
the command used to change the gpio mode and state:
'set gpio range=1-5 mode=output state=asserted/deasserted'
asked May 30, 2016 in Plug N' Play by m271828ngtao New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Digi Connect Family Users Guide

set gpio
set gpio displays current GPIO pin settings. You can reconfigure the pin settings as needed.

display gpio
answered Jul 11, 2016 by LeonidM Veteran of the Digi Community (4,444 points)
change the state of gpios immediately without reboot
You can find the most up-to-date version of the Digi Connect Family User Guide at https://www.digi.com/resources/documentation/digidocs/90000565/default.htm. (Note that the PDF is available from the footer of the document.)