Home/Support/Support Forum/There is not an active bootloader in the module in Xbee pro s1 usinng XCTU 6.3.0..please help me
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

There is not an active bootloader in the module in Xbee pro s1 usinng XCTU 6.3.0..please help me

0 votes
asked Jun 7, 2016 in IEEE 802.15.4 by irfan153 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You are going to need to try to use the recovery function of XCTU. If that does not work, there is nothing else you can do except contact Digi for an RMA only if the module is under warranty.
answered Jun 7, 2016 by mvut Veteran of the Digi Community (15,323 points)
Thanks for your feedback.

Actually my mistakenly i update the wrong firmware and after that i faced this problem...if you know any solution please let me inform
Advance thanks
commented Jun 7, 2016 by irfan153 New to the Community (0 points)
Try using the XBee recovery function in XCTU to load the proper firmware on the radio. Make sure you do this using a board that has the DTR and RTS lines connected or it may not work.
commented Jun 8, 2016 by mvut Veteran of the Digi Community (15,323 points)
...