Home/Support/Support Forum/3x xstream pkgs bricked? blinking red light after trying to write new baudrate checksum fail. is there any fix?

3x xstream pkgs bricked? blinking red light after trying to write new baudrate checksum fail. is there any fix?

0 votes
I used xctu, connected read settings fine on Xstream pkg x09-009pkc-r. changed baudrate for application to be used for (from 2400 to 9600). got a message saying checksum fail during write. now all units 3 of them just blinking red led. won't go into config mode (yellow led holding button on pwr up). tried switches 1&2 up on power up, no change. tried restore in xctu but it says user abort..

Please help

Thank you!
asked Jun 20, 2016 in XStream by mkrehel New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Enable the hardware flow control function in XCTU and the try to do a restore. Make sure you do it at the default baud rate of 9600.
answered Jun 20, 2016 by mvut Veteran of the Digi Community (11,300 points)
...