Home/Support/Support Forum/xb24c 802.15.4 how to set as router?

xb24c 802.15.4 how to set as router?

0 votes
Good morning,
I updated two xb24c with the firmware 802.15.4 SMT because i need to change manually the channel, the PAN ID and the Adress. After the update the two module are set as End Device, I found how to set the module as Coordinator, but I don't understand how to set the module as ROUTER. Could You help me?
Thank You. Best Regards. Marco
asked Jun 20, 2016 in IEEE 802.15.4 by mpbejo71 New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
The 802.15.4 IEEE standard does not support Routers. You need to use the default firmware for the S2C of you want Mesh.
answered Jun 20, 2016 by mvut Veteran of the Digi Community (11,302 points)
selected Jun 20, 2016 by mpbejo71
Thank You for your reply. But if I use the default firmware I see that the channel and the address are only READ. So how can i change manually these values?
By default, the S2C is a Zigbee Router.  You need to set the CE command to 1 to enable a Zigbee Coordinator and allow the router to associate or Join.
...