Home/Support/Support Forum/how to configure XCTU 6.3.1
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

how to configure XCTU 6.3.1

0 votes
Hi,

I've ZigBee 865/868LP how can I configure its PAN ID, how to set it into API mode, AT mode, router coordinator, I don't find any setting.
It shows lot of section but completely different name then the previous versions. I really don't find. help me on this.

Thanks

Abhinav
asked Jun 27, 2016 in IEEE 802.11 (Wi-Fi) by Abhi_d New to the Community (3 points)

Please log in or register to answer this question.

3 Answers

0 votes
The XBee 868 LP is NOT a Zigbee enabled product. There for there is no Coordinator, router or end device specific function. It is a true to peer product. To transmit data to a given node, you only set the DL and DH to match the receiving modules Sl and SH.
answered Jun 27, 2016 by mvut Veteran of the Digi Community (15,223 points)
Means I can't form network with  ZigBee 868 LP??
ZigBee product sheet says that it supports multipoint and digimesh protocol. also says peer to peer mesh ??? It's confusing, how mesh could be formed by peer to peer???
pls explain.

I just want to make mesh network using 868LP.
commented Jun 28, 2016 by Abhi_d New to the Community (3 points)
edited Jun 28, 2016 by Abhi_d
0 votes
Means I can't form network with ZigBee 868 LP??
answered Jun 28, 2016 by Abhi_d New to the Community (3 points)
0 votes
Can I get any reply, pls???? it's urgent.
answered Jun 30, 2016 by Abhi_d New to the Community (3 points)
...