Home/Support/Support Forum/Wh would my xbee Series 1 End Point Constantly Chat with the Coordinator?

Wh would my xbee Series 1 End Point Constantly Chat with the Coordinator?

0 votes
I have a very simple test where I am trying to have a Series 1 End Point communicate with a Series 1 Coordinator.

However, without doing anything other than powering the devices, the Coordinator starts receiving data from the End Point (constantly). Any idea why this would be happening?

The frame that I am receiving (over and over again) looks like this:

7E, 0, 10, 82, 0, 13, A2, 0, 40, C2, 21, D1, 2C, 0, 1, 0, 10, 0, 10, 87

Thanks!

Dave
asked Jul 5, 2016 in IEEE 802.15.4 by granvillemaker New to the Community (1 point)
edited Jul 5, 2016 by granvillemaker

Please log in or register to answer this question.

1 Answer

0 votes
I'm pretty new to all this, but I had something similar due to Sample Rate (IR) on the End device. If it's not set to (0) it will send data at a constant rate.

What configuration software are you using?
What have you changed in the device configuration so far?

If all else fails, just restore -> write to reset the devices to firmware defaults.
answered Jul 6, 2016 by DystopianFerret Veteran of the Digi Community (365 points)
...