Home/Support/Support Forum/Effect of RF frequency on S2C
New and improved user forum site going live on 12/6 (All users will need to reset their password when the new forum is active)

Effect of RF frequency on S2C

0 votes
I am using Xbee S2C.
I have tried to check effect of other RF devices on Xbee S2C using walky-talky of frequency range 100Mhz- 512Mhz.
when walky - talky is taken near to S2C < 20cm , receive signal strength (measured using remote AT command DB) reduces abruptly.
please guide is there are any special instruction to be followed for PCB layout ,
Is there any document saying effect of other frequencies on S2C module
asked Jul 15, 2016 in IEEE 802.15.4 by Sheetal Kasar New to the Community (3 points)

Please log in or register to answer this question.

1 Answer

0 votes
Design notes for PCB layout are mentioned in product manual. Check them out:
answered Jul 18, 2016 by asgm Veteran of the Digi Community (1,499 points)