Home/Support/Support Forum/transalate ip address using firewall rule
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

transalate ip address using firewall rule

+1 vote
I want configure Digi Transport wr44 firewall, to translate the source IP ( from to, i added the following rule.
pass in break end on eth 1 from to -> to

My question, does this means, for all traffic coming on ETH1, the DIGI will translate source address from to

because it's not working.
since, i have VPN tunnel up, from remote subnet and local subnet
And i don't see nothing when i ping from

in other side i implement other rule
pass in break end oneroute any from to -> to

and it works, i can ping from

please help me.
best regards
asked Jul 28, 2016 in Digi TransPort Cellular by abhamid New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes

to answer you question the answer is NO

only traffic that is going to from will be translated this will then enter the router and where it goes from there depends on configuration and routing.

have you taken analyser traces to see what is going into the VPN and what is coming out on the other end.


answered Jul 29, 2016 by James.Wilson Veteran of the Digi Community (1,227 points)