Home/Support/Support Forum/setDIOChangeDetection

setDIOChangeDetection

0 votes
Hi all,
I don't know if this is the rigth category to speak about zigbee.

I am using S2 pro and I am not able to use setDIOChangeDetection capability.

Does anyone have the same problem? or similar?
I could post the code and configuration if needed.

Regards,
Matteo.
asked Jul 29, 2016 in ZigBee PRO Featureset (and legacy ZNet 2.5) by kratos New to the Community (1 point)
recategorized Jul 29, 2016 by michaelt

Please log in or register to answer this question.

2 Answers

0 votes
The IC command is a Bit mask where each bit is an enabled line. Have you enabled this function? Are you trying to perform a Digital IO line pass function?
answered Aug 1, 2016 by mvut Veteran of the Digi Community (12,544 points)
0 votes
Hi,
thanks for the answer, but I have solved my trouble. It was my fault, I had set AO to 1 (explicit) on coordinator, so it translated the sample message in explicit message.

Bye,
Matteo.
answered Aug 2, 2016 by kratos New to the Community (1 point)
...