Home/Support/Support Forum/Xbee PRO 900HP wont stay in cyclical sleep mode.

Xbee PRO 900HP wont stay in cyclical sleep mode.

0 votes
Using an XBee PRO 900HP (firmware 1074)

I am trying to get it to go into a cyclical sleep mode. E.g. SM4

I've set SP = 300, ST = 1, SN = 1. I can tell the
module wakes up every 3 seconds. Great so far.

When I turn on data sampling. E.g. D1 =2 (AD1) and IF=1 the module wakes up and starts sending data, but it never goes back to sleep.

I've noticed that with all the above settings it will initially sleep after power on, but once it wakes up that first time it wont go back to sleep.

I've successfully used XB24/XBP24 modules to do the same and had no problems.

Looked through the manual for the module and I don't see anything that would cause this.

Anyone seen this before ?

Thanks.
asked Aug 2, 2016 in Multipoint Proprietary by rasmussenc New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
Check your IR value. I bet you are sampling on a continuous basis.
answered Aug 2, 2016 by mvut Veteran of the Digi Community (11,300 points)
selected Aug 2, 2016 by rasmussenc
Yes, that was it. Was set to 1. And I "guess" as long as there is 'traffic' the module extends the sleep by what ever is set in ST. Hence it never went back to sleep. Thank you.
...