Home/Support/Support Forum/XBEE ZB-Pro remote DIO problem

XBEE ZB-Pro remote DIO problem

0 votes
I am trying to set the DIO pin as output High/Low in a remote device in a Zigbee network from the coordinator. I am following exactly the example from the knowledge base http://knowledge.digi.com/articles/Knowledge_Base_Article/Using-Remote-AT-Commands-to-Toggle-an-IO-on-a-Remote-XBee-ZB-Radio
I am successful to an extend. The pin does set to DO High/Low but then after a few seconds it returns to its initial "disable" state.
I would like to fully control the IO pins on remote XBEE devices. Any help would be highly appreciated.
I am using an XBEE ZB-Pro S2C device with the latest 4059 firmwire
asked Aug 7, 2016 in RF Solutions and XBee by paknick New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Look to the TO command for that specific line.
answered Aug 8, 2016 by mvut Veteran of the Digi Community (11,302 points)
...