Home/Support/Support Forum/XBee Pro Module error number of red

XBee Pro Module error number of red

0 votes
Dear good afternoon , I have problems with one of the XBee Pro Module - ZB Series 2SC - 63MW with Wire Antenna - XBP24CZ7WIT - 004

I would like to see if they can give me an example with the following:

1) Coordinator, which has enabled a digital output to refresh the input status of the Router.

2) Router, which has enabled a digital input.

With an example so you could try directly upload files to open with the X-CTU and this load on each Xbee.

To rule out serious the problem is the software.

Thank you very much in advance.

Best regards.
asked Aug 10, 2016 in XCTU by Adichip New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
The default Zigbee version of the firmware for this product does not support that function.
answered Aug 18, 2016 by mvut Veteran of the Digi Community (12,791 points)
...