Home/Support/Support Forum/Configure Ethernet-2 port on Digi Passport console servers
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Configure Ethernet-2 port on Digi Passport console servers

0 votes
Hi all,

I have been trying to configure an IP on ethernet-2 port of a digi passport without success. This is mainly for redundancy in case the primary link to the console server is down.
Any help is certainly appreciated.

Thanks,
asked Aug 18, 2016 in Console Servers by sourathe New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
Does the info on page 279 of the doc linked below help?

http://ftp1.digi.com/support/documentation/90000767_F.pdf
answered Aug 19, 2016 by jeremym Veteran of the Digi Community (1,673 points)
0 votes
Yes, that did not help. The commands on page 274 are meant for what I am trying to accomplish but I can't quite save the configs I change "The current configurations are not the latest one, please reload configurations".

Thanks for your help!
answered Aug 22, 2016 by sourathe New to the Community (1 point)
I have managed to get it working by bridging the two Ethernet ports. This enables the fail-over in case the link on the 1st port is down and vice versa.

Thanks Jeremy!
...