I have some XBee S2C modules (XBP24CZ7WIT-004, all connected to Arduino's) with which I want to make the following set-up:
* 1 coordinator and a number of routers controlling certain areas in a big hall. All set up so they can talk with each other (are in range of 1 neighbour at least).
* A number of moving end devices (let's say 20 - 40) moving around in the hall. Sometimes they will be in range of one of the routers, a bit later not anymore but in range of another router.
The end devices will have a list stored of the routers & coordinator. At a certain moment of choice I want them to send a message (using API 2) to one of the routers, irrespective of where they are now (possibly with another one as a parent) and receive an answer from this router.
So my questions:
1) The end devices will have to do "roaming" between routers. Once they lose connection to a router they automatically have to search for another router or coordinator to connect to. In other words, I think, they will have to rejoin the PAN once they lose connection, and then just select the best node in the PAN as new parent. Will this happen automatically out of the box? Or do I need some setup? Or do I need to monitor for a Modem Status message in my Arduino telling it that connection has been lost and then specifically send a rejoin API message to the XBee? I hope this wouldn't be necessary, to minimize the load on the Arduino.
2) After rejoin, be it fully automatically or by an API message from the Arduino, will the routing tables be adjusted in the routers? In other words, will responses to the end device still get to their destination? Fully automatic, without any action from my Arduino software?
I would have thought that an answer to this would be readily available somewhere but it seems I keep searching on the wrong search terms. I just can't seem to find it.
Davy Van Rossem