Home/Support/Support Forum/XB24-B can't be seen in XCTU 6.2 when configured as Zigbee Coordinator API mode

XB24-B can't be seen in XCTU 6.2 when configured as Zigbee Coordinator API mode

0 votes
Hi I have Xbee Radios Series 2 (XB24-B), I used them with XCTU 6.3.2 in AT mode without any problem.
Now, because I have to do a star topology network (1 coordinator and 4 end devices)I need to go in API mode.

I started uploading the firmware of the AT coordinator in the first Radio and as a result XCTU 6.3.2 does not see the radio anymore.

However if I send packets to the radio through the UART it responds correctly, so I guess that there must be some problems between my radios and the XCTU when in API mode,
anyone can help?
asked Sep 15, 2016 in ZigBee PRO Featureset (and legacy ZNet 2.5) by carmix New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
Try removing and adding it back in.

What firmware version did you load on that module?

How is the module connected to the PC?
answered Sep 16, 2016 by mvut Veteran of the Digi Community (12,834 points)
0 votes
Doing some tests I found that the problem does not presents if I load a ZNet firmware in place of ZigBee one.
Maybe simply my radios are too old and do not fully support Zigbee
answered Sep 19, 2016 by carmix New to the Community (1 point)
...