Home/Support/Support Forum/ConnectCore i.MX53 JTAG halt
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

ConnectCore i.MX53 JTAG halt

0 votes
Trying to connect a j-link to a CC-WMX53-LX.

JTAG seems to work but for some reason halting doesn't work when writing program to RAM.

J-Link found 3 JTAG devices, Total IRLen = 13
JTAG ID: 0x1BA00477 (Cortex-A8)
Connected to target
Waiting for GDB connection...Connected to 127.0.0.1
Reading all registers
Read 4 bytes @ address 0x7780D6E8 (Data = 0xE0623003)
Read 4 bytes @ address 0x00000000 (Data = 0xE59FF01C)
WARNING: CPU not halted after Reset, halting using Halt request
WARNING: CPU could not be halted
ERROR: Bad JTAG communication: Write to IR: Expected 0x1, got 0xF (TAP Command : 10) @ Off 0x5.

Resetting target
WARNING: CPU could not be halted
WARNING: Failed to read memory @ address 0x7780D6C8
WARNING: CPU could not be halted
WARNING: Failed to read memory @ address 0x7780D6C8
Downloading 4096 bytes @ address 0x70000000WARNING: CPU could not be halted
WARNING: CPU could not be halted
- Verify failed
Downloading 4096 bytes @ address 0x70001000WARNING: CPU could not be halted
WARNING: CPU could not be halted
- Verify failed
asked Oct 10, 2016 in Embedded Devices by majo New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
you must be using an unsupported JTAG dongle
answered Nov 5, 2016 by LeonidM Veteran of the Digi Community (3,863 points)
Where can I find a list of these supported dongles?
Developers used Ronetix PEEDI, but nothing is officialy supported by Digi
Where can I find this list of supported JTAG dongles?
...