Home/Support/Support Forum/868LP Factory reset

868LP Factory reset

0 votes
Hi there, Is it possible to factory reset XBee 868LP (programmable) Module?
I think I disabled DIN pin by mistake in XCTU and I can't connect the module anymore.

Or maybe there is a way to reenable DIN again? Please help me.
asked Oct 12, 2016 in XCTU by mcdenko New to the Community (2 points)
edited Oct 12, 2016 by mcdenko

Please log in or register to answer this question.

1 Answer

+1 vote
 
Best answer
You can either send Remote AT command from another module to enable DIN again ('P4' parameter)

Or press Commissioning button 4 times in a row to restore parameters to default on modules (only applicable if 'D0' parameter is not changed from default value).
answered Oct 13, 2016 by asgm Veteran of the Digi Community (1,498 points)
selected Oct 13, 2016 by mcdenko
Thank You Very Much!
...