Home/Support/Support Forum/Connect Digimesh and HC-05 (bluetooth) : build a bridge (without Arduino)

Connect Digimesh and HC-05 (bluetooth) : build a bridge (without Arduino)

0 votes
Hi,

I'm trying to build a "bridge / converter" connecting in direct a DigiMesh module (XB24-DMPIT-250) and a HC-05 bluetooth module (so without using an Arduino).

PC <<<air>>> (HC-05)--wire--(DM) <<<air>>> remote DM

Goal is to send API frame from a bluetooth device (a PC) to a remote DigiMesh module and get the responses.

Configuration :
- Digimesh is 3.3V powered and 5v for HC-05.
- Tx DM connected to Rx HC-05 / Rx DM connected to Tx HC-05.
- Both have same serial configuration (38400,N/1/N).

It works only for one direction : I can send data from the PC and see data received on remote DigiMesh module (using xbee usb explorer)

But I'm not able to get the response, i.e data send by remote DM module to the PC.

It is doable ? I forgot something ?

Thanks a lot, best regards,
asked Nov 29, 2016 in DigiMesh Proprietary Mesh Networking by Albalister New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Check if the DigiMesh radios are configured for 2 way communication.
answered Nov 30, 2016 by DystopianFerret Veteran of the Digi Community (365 points)
...