Home/Support/Support Forum/Need help on Xbee transmitter randomly freezing.

Need help on Xbee transmitter randomly freezing.

0 votes
I have two XB24-AWI chips in API mode (function Set: 802.15.4 / Firmware: 10ef)

I'm pressing a button attached to DI0 on the end device, it seems to just stop transmitting frames randomly after 20 or so seconds. Then will resume again after a bit of a delay.

Only relavant settings that are not default are:
AP = API Enabled [1]
DIO0 = DI [3]
IC "DIO CHANGE DETECT" = FF

Could anyone suggest possible causes for a random delay in transmitting?
asked Nov 29, 2016 in IEEE 802.15.4 by nekorbin New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Try setting T0 to a lower value.
answered Nov 29, 2016 by DystopianFerret Veteran of the Digi Community (368 points)
...