Home/Support/Support Forum/how to configure a xbee pro s2 coordinator to RX and Tx?

how to configure a xbee pro s2 coordinator to RX and Tx?

0 votes
The mesh consist in three points:
1 end device as analogue sensors signals Rx.
1 router device to operates a pump and connects the end device and the coordinator due to the distance.
1 coordinator to Rx the signal and Tx the on - off signal to operates the pump.
The sensors signals are analogue and the on-off signal is a digital one.
How to configure these devices?

Regards
Nicolas
asked Nov 29, 2016 in ZigBee PRO Featureset (and legacy ZNet 2.5) by nicorodri New to the Community (4 points)

Please log in or register to answer this question.

2 Answers

0 votes
What do you mean by "configure"?

Are you asking how to set up the ZigBee network?
Are you asking how to set up the sensors?
Are you asking how to set up the Rx/Tx triggers on the coordinator?
answered Nov 29, 2016 by DystopianFerret Veteran of the Digi Community (365 points)
0 votes
Hi DystopianFerret,
Thank you very much! I've been working on several issue, however I would like to retake this subject. My doubt is how to set up the Rx/Tx triggers on the coordinator?

Kinds Regards
answered Apr 7, 2017 by nicorodri New to the Community (4 points)
...