Home/Support/Support Forum/problme at XCTU to configure xbee pro S3B

problme at XCTU to configure xbee pro S3B

0 votes
hi
when i want to configure my xbee module i give a error like "Device not found"
so i do something ...
for example i go to recovery but i get the error "bootloarder not found"
..
how can i do??
asked Nov 29, 2016 in XBee Programmable Development by ali-niri New to the Community (0 points)
retagged Nov 20, 2016 by ali-niri

Please log in or register to answer this question.

1 Answer

0 votes
It sounds like you have a faulty module.

Please follow the instructions here: http://www.digi.com/resources/documentation/digidocs/90001458-13/default.htm#reference/r_xbee_recovery_tool.htm

Make sure that you are loading the correct firmware according to the product family of your radio.

If these do not work for you, please post the full part number located on the white label on your radio. It should start with XB and end with REV
answered Nov 29, 2016 by DystopianFerret Veteran of the Digi Community (368 points)
...