Home/Support/Support Forum/XBee pro s2b and XBee peo s2c communication

XBee pro s2b and XBee peo s2c communication

0 votes
Hi! I'm working on a project but it seems that my 2 modules are not communicating.
At first, using test terminals the modules are ok but as the s2b send a message but the s2c are receiving extra unwanted characters. I tried to fix it bit then.
I cannot communicate both of them.

What should i do?
asked Dec 13, 2016 in RF Solutions and XBee by Shine J New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

+1 vote
Try restoring to defaults first. Then make sure both are NOT in API mode.

Make sure one of them is configured as the Coordinator.
answered Dec 14, 2016 by mvut Veteran of the Digi Community (13,333 points)
Thank you for the answer sir :)

Yes. Only One is in API mode and also, only one is set as coordinator.
Are the extra characters coming from the node that is in API mode?
...