Home/Support/Support Forum/send data between xbee s2 series in API mode

send data between xbee s2 series in API mode

0 votes
sorry.. i want to ask..
how to print data ony without print the acknowledgment between xbee s2 in API mode???
please help me,,,

how about the sketch....

thx very much
asked Dec 29, 2016 in XBee Programmable Development by sams99 New to the Community (4 points)

Please log in or register to answer this question.

1 Answer

0 votes
If you are using API mode you can either set the Frame ID to 00 or set the option bit to 01.
answered Dec 29, 2016 by mvut Veteran of the Digi Community (15,355 points)
where is it in xctu?? SB, NB or etc?
It is not an AT command.  It is part of the API frame I was referring to that you assemble.
...