Home/Support/Support Forum/changing xbee s1 wire antenna and attach an SMA connector

changing xbee s1 wire antenna and attach an SMA connector

0 votes
Dear Admin,

I have read a post regarding changing an XBEE series1 1mw chip antenna to attach a different connector and you mentioned to the poster that its a bot challenging.

my question if i can take out the wire antenna on models that i have and attach either a ufl connector to then attach an SMA cable connector, or if possible to attach an SMA connector directly.

if it is possible to do the above please guide me through this. I am a researcher and i need to have this capability.

appreciate any suggestions.

thank you in advance [:D]

asked Dec 21, 2012 in IEEE 802.15.4 by marwan New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
maybe you need a SMA to u.fl assmebly, so you can connector them, or take one SMA to U.FL adapter?

pics as follow link:


answered Jul 15, 2014 by krfine New to the Community (2 points)
0 votes
Adding a U.FL connector may be possible if you make the proper connections (the warranty will be void). But going to RPSMA or SMA will not be possible as that is a different PCB layout for it.
answered Jul 16, 2014 by mvut Veteran of the Digi Community (10,818 points)
Contact a Digi expert and get started today! Contact Us