Home/Support/Support Forum/Intermediate 110 kbps DigiMesh firmware for 900HP S3B modules ?

Intermediate 110 kbps DigiMesh firmware for 900HP S3B modules ?

0 votes
Hi,

I'm currently using 900HP S3B modules with the 200Kbps DigiMesh firmware in my network. Problem is that i need longer range transmission but still use the DigiMesh capabilities of it. DigiMesh is not available for the long range 10 Kbps S3B firmware.

I was checking on the XBee SX modules datasheet and there is a command to set the RF data rate there:

ATBR (RF Data Rate)
0 - 10 kb/s -113 dBm (P2MP)
1 - 110 kb/s -106 dBm (DigiMesh)
2 - 250 kb/s -103 dBm (DigiMesh)

As in the S3B modules, the SX doesn't support DigiMesh protocol if ATBR = 0 (10 kbps). But it does accept DigiMesh if ATBR = 1 (110 kbps).
So i was wondering if Digi could also release a middle term data rate firmware for the S3B ? A 110 Kbps like the SX modules.

Also, i didn't find in the SX datasheet the distance range when ATBR = 1, only for ATBR = 0 (Up to 14.5 km).
asked Jan 13, 2017 in DigiMesh Proprietary Mesh Networking by brunoaduarte New to the Community (11 points)
edited Jan 13, 2017 by brunoaduarte

Please log in or register to answer this question.

1 Answer

0 votes
That is something you would need to bring up with Digi Sales.
answered Jan 17, 2017 by mvut Veteran of the Digi Community (11,354 points)
...