Home/Support/Support Forum/Missing Supply Voltage option - XBee S1

Missing Supply Voltage option - XBee S1

0 votes
The AT command for viewing supply voltage according to all documentation I've ready is AT%V. I however get an error on my XBee Series 1.

It does not appear in XCTU either, as it does for my ZigBees.
asked Jan 23, 2017 in IEEE 802.15.4 by trefrosk New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
That is because that command is not supported by the S1 hardware. That is a Zigbee enabled hardware command.
answered Jan 23, 2017 by mvut Veteran of the Digi Community (11,450 points)
That's what I was afraid of.  Thanks.
...